User Guide

11 | P a g e © Adam Equipment Company 2010
6.4 PARTS COUNTING
If parts counting is enabled, See section 7.4, it is possible to count parts using a
sample of the parts to determine average piece weight.
• Before starting, tare the weight of any container that may be used,
leaving the empty container on the scale. Place a known number of
samples in the container, if used. The number should match the
options for parts counting, i.e., 10, 20, 50, 100 or 200 pieces.
• When the scale is showing weight, pressing the [Pcs/

] key will start
the parts counting function.
• The scale will show “P 10” asking for a sample size of 10 parts. Change
the sample size to the desired quantity by pressing the [Pcs/

] key. It
will cycle through the options: 10, 20, 50, 100, 200 and back to 10.
• Press the [Z/T] key again when the number matches the number of
parts used as the sample. As more weight is added the display will
show the number of parts (Pcs).
• Pressing the [Unit/

] key will display the unit weight (g/pcs), pressing
it second time will display the net weight (pcs and kg) and the third
time, it will be the count again (pcs).