Product Manual



 To charge the battery, simply plug into the mains power supply. The indicator does

not need to be turned on. Once fully charged remove the mains power supply to

help protect the battery.

 The battery should be charged for 8 hours for full capacity.

 To the right of the display is a LED to indicate the battery charging status. When

the indicator is plugged into the mains power the internal battery will be charged. If

the LED is red the indicator needs to be put on charge, the LED will continue to stay

red until the battery is fully charged. When the indicator is fully charged the LED will

turn green.

5.1 BACKLIGHT

The backlight for the LCD can be set by the user to always off, always on or

automatic (on only when the indicator is in use or a key is pressed). See

setting of the parameter “P3 FUN BL” in section 10.3.

5.2 SLEEP MODE

Sleep mode can be set by the user to disable the feature or to a pre-set time

interval. See setting of the parameter “P3 FUN PWR” in section 10.3.

6.0 OPERATION

6.1 ZEROING

 You can press the [Zero] key at any time to set the zero point from which all other

weighing and counting is measured. This will usually be necessary when the

platform is empty. When the zero point is obtained the display will show the zero

indicator.

 The indicator has an automatic re-zeroing function to account for minor drifting or

accumulation of material on a connected platform. However, you may need to press

[Zero] to re-zero the indicator if small amount of weight is still shown when the

platform is empty.