Product Manual



6.2 TARING

6.2.1 Manual tare



 Zero the indicator by pressing [Zero]. The zero indicator will be on. Place a

container on the pan and its weight will be displayed.

 Press [Tare] when the reading is stable. The weight that was displayed is stored as

the tare value and it is subtracted from the display, leaving zero on the display. The

stable and Tare will be on.

 As a product is added only the weight of the product will be shown. The indicator

could be tared a second time if another type of product was to be added to the first

one. Again, only the weight that is added after taring will be displayed.

NOTE:

When the container is removed a negative value will be shown. If the indicator was

tared just before removing the container, this value is the gross weight of the

container plus all products which were removed. The zero indicator will also be on

as the platform is back to the same condition it was when [Zero] was pressed last.

If the value to be tared is very large the scale may not allow you to tare the value as the

negative value will not fit on the display area. In this case the scale will beep twice when

the [Tare] key is pressed and then return to normal weighing without setting tare.

6.3 WEIGHING

To determine the weight of a sample, first tare an empty container if used, then place the

sample in the container. The display will show the weight and the unit of weight currently in

use.