Product Manual



 If the parts are too light to measure accurately, the count may become faulty. It is

suggested that the samples to be weighed should each weigh more than the

resolution of the indicator.

 After the sample has been weighed the indicator will count any other parts added by

applying the average piece weight to the weight of the parts to be counted.

 The [Tare] key works normally during this time, so it is possible to tare the display

with a container on the platform.

 To count a different sample quantity press [Mode/Print]. The display will show the

last used sample size. Either use this sample size with a different part or enter a

new sample size as above.

Press [Units] to return back to normal weighing mode. If the sample is left on the platform

the weight of the sample will be displayed.

6.5 CHECK-WEIGHING

Check-weighing is a procedure that can be displayed on the indicator or via an alarm when

the weight on the platform meets or exceeds the values stored in the memory. The

memory holds values for a high limit and a low limit. Either or both the limits can be set by

the user.

NOTE:

The LCD display will indicate whenever the weight is within or exceeds the limits by

showing ‘OK’, ‘HI’ or ‘LO’.