Product Manual



NOTE: The single hyphen depicted in the table above represents the flashing hyphen

which means the beep is on.

 Press [Units] to select the desired alarm setting.

 Press [Mode/Print] to save the selected alarm setting and to move on to setting the

high and low limits.

 The display will show “H000.00” with one digit flashing.

 To set the high limit, Press [Units] to select the digit.

 Press [Tare] to increase the flashing digit and [Zero] to decrease the flashing digit

as necessary.

 Press [Mode/Print] to accept the high limit and move on to set the low limit. The

display will show “L000.00” with one digit flashing. Use the same method to set the

low limits and press [Mode/Print] to confirm the low limit. The parameters will be

saved and return to normal weighing mode.

6.5.2 Setting up while parts counting or % weighing



During parts counting and percent weighing the limits are set in the same way as above.

The limits are displayed in pcs or %.

6.6 PERCENT WEIGHING

The indicator can be set to perform percent weighing.

The indicator will use a mass on the platform as the 100% reference weight.

 In normal weighing mode, press [Units] until the display shows “PCS”.

 Press [Mode/Print] twice to move into percentage weighing.

 The display will show “S – 100%” which stands for the 100% reference weight (or

object).

 Add the reference weight to the to the platform and press [MR] The indicator will set

the sample mass on the platform as 100% reference weight and enter percentage

weighing.