Product Manual


© Adam Equipment Company 2019 36
X ZTR Creep tracking: When load cell creeps set
this parameter to help stabilize the
indicator. The load cell creep is often
caused by environmental conditions and
other variables.
0 (low) – 5 (high)
Press [Tare] to increase
value, [Zero] to decrease
value and [Mode/Print] to
move on to the next
parameter. Then press [MR]
to return to Menu.
12.1.2 Capacity and division (P5 C-D)
Parameter Description Option
XXXX CAP XXXX is capacity, when weight is more than
+9d of this parameter the scale will show an
error message.
Press [Units] to modify the
decimal point, press [Tare]
and [zero] to modify digits.
Press [Mode/print] to move
on to the next parameter.
XXXX DIV Division setting: Set minimum resolution
depending on precision requirements.
0.01, 0.02, 0.05, 0.1,
0.0001, 0.0002, 0.0005,
0.001, 0.002, 0.005.
Press [Tare] to increase
value, [Zero] to decrease
value and [Mode/Print] to
move on to the next
parameter.
XX HP Dual division setting: Enable or disable. Set to On or OFF using the
[units] key, [Mode/Print] to
confirm.
Then display shows ‘’Off dp‘’; press [Mode/Print] to return to menu.