Product Manual

subtracted from the display, leaving zero on the display. The

indicator “Net” will be on.

• As a product is added to the container, only the weight of the

product will be shown. The scale could be tared a second

time if another type of product was to be added to the first

one. Again only the weight of the product that is added after

taring will be displayed.

• When the container is removed a negative value will be

shown. If the scale was tared just before removing the

container, this value is the gross weight of the container plus

all products. The zero indicator will also be on because the

platform is back to the same condition as it was when the

[Tare/Zero] key was pressed last.

Note: If the capacity of the scale is 6000g and a container

weighing 2450g is used and tared, the scale can then be

used to weigh the material of up to 3550g.

10.4 SELECTING THE UNIT

To select the weighing unit press the [Unit] key to move form one unit to

another. The weighing unit must be enabled by the users beforehand

(see section 13.1.3). If a unit is disabled it cannot be selected by using

the [Unit] key.

10.5 WEIGHING

• When the scale is at zero, place an item to be weighed on

the platform. The display will show the weight in the unit

selected previously. The weighing result can be viewed in

other enabled units using the [Unit] key.

• If a container is used, this can be tared as described in 10.3.

The scale then shows the net weight of the material added.