User Guide

3 © Adam Equipment Company 2013
2) Remove the shipping protection screw and transit disc from the top of the
balance
3) Place the Beaker Support assembly onto the top housing with the
Temperature Sensor cable running down the back of the balance.
4) Lift the beaker away to the rear and locate the Density Chamber support into
the receptacle with the arrow facing the rear of the balance. Press gently to
insert it then secure the support in the center using the M4 x 20mm screw
which is packed in the accessory bag. Tighten only enough to secure the pan
support so that it does not rock in the receptacle.