Safety data sheet

Adam Hall GmbH · Daimlerstraße 9 · D-61267 Neu-Anspach
Telefon: [phone] / 94 19 - 0 · Fax: [phone] / 94 19 - 1000 · www.adamhall.com
Notes regarding fire and explosion protection
Do not spray on a naked flame or any incandescent material. Protect from sunlight and
do not expose to temperatures exceeding 50 °C/122 °F Keep away from sources of ignition - No smoking.
Take precautionary measures against static discharges. Vapours form explosive mixtures with air.
Gemische bilden.
7.2. Conditions for safe storage, including any incompatibilities
Requirements for storage rooms and containers
Keep container tightly closed. Keep container in a cool, well ventilated place. Von
Keep away from heat/sparks/naked flames/hot surfaces. Do not smoke during use.
Instructions on joint storing
Do not store together with: material rich in oxygen, oxidizers. Pyrophoric or
self-heating hazards.
Storage class according to Technical Rule 510: 2 B
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limit values (TRGS 900)
CAS No. Designation ppm mg/m³ F/m³ Spitzenbegr. Type
115-10-6
67-64-1
Dimethyl ether
Acetone
1000
500
1900
1200 2 (l)
AGW
Biological limit values (TRGS 903)
CAS No. Designation Parameter Limit value Unters.- material Samples.- date
67-64-1 Acetone Acetone 80 mg/l b
8.2. Exposure controls
Suitable technical control systems
With open handling, use devices with local suction.
Do not inhale gas/fumes/vapour/aerosol
Protection and hygiene measures
Take off all contaminated clothing immediately. Create and follow the skin protection plan! Before
breaks and after finishing work, wash your hands and face thoroughly, shower if necessary.
While working, do not eat and drink.
Eye/face protection
Wear eye protection/face protection. Suitable eye protection: safety glasses with side shields
Hand protection
When dealing with chemical agents, only chemical protective gloves with
EC mark including four-digit verification code may be worn. Chemical protective gloves
are to be selected according to their suitability for the work place, and depending on concentration and
quantity of hazardous material.
arbeitsplatzspezifisch auszuwählen. Suitable material: NBR (nitrile rubber), CR (polychloroprene,
chloroprene rubber), penetration time (maximum wear) >480 min (EN 374) It is
recommended that the chemical resistance of above mentioned protective gloves for special
applications be clarified with the glove manufacturer.
Body protection
Wear anti-static shoes and work clothes.
Respiratory protection
In case of inadequate ventilation wear respiratory protection. Filtering device (DIN EN 147) Filter type: AX for
low boilers of Group II can be used at maximum contaminant concentration in the ambient air of 1000