User Manual

16
S SERIES MANUAL [ENGLISH]
Preset 1
Pure
Preset 2
UNR
Preset 3
Classic/User1
Preset 4
User1/User2
Preset 5
User2/User3
activate
activate activate
click click click click click
rotate rotate rotate rotate rotate
rotate rotate rotate rotate rotate
EQ Menu
(4)
click
long
click
activate
EQ Menu
(4)
click
long
click
activate
EQ Menu
(4)
click
long
click
Top
Menu (1)
long
click
long
click
long
click
long
click
long
click
Preset Menu [3]: The EQ Preset selection menu. Note that Preset 3 is the S3A-emulating
‘Classic’ preset on the S3H, but is User Preset 1 on all the other S Series models.
When one of the user presets is shown in the display, tapping the encoder activates that
preset. A second tap on the encoder accesses the next menu layer down, where the
specific EQ settings for that preset may be adjusted. Rotating the encoder at this level
brings up the low shelving filter, then each of the six parametric EQs in turn [logically
numbered EQ 1, EQ 2 and so on], and finally the high shelving filter. Selecting one of these
filters takes you down to the lowest levels of the menu interface, where the individual
parameters for each filter can be changed. Selecting one of the shelving filters leads
to options for corner frequency in Hz and a Gain [Boost or Cut] setting, calibrated from
-12 to +12 dB in 0.5 dB increments. Of course, when you select one of the six parametric
EQs, there is also a Q [bandwidth] setting in addition to the turnover frequency and Gain
settings. As always, once these parameters have been set to your satisfaction, pressing
the rotary encoder stores the selected settings [accompanied by the brief appearance
of the star at the top of the display], while pressing and holding the encoder down for a
short time moves you back up one level in the menu structure.