User's Manual
Table Of Contents
- CONGRATULATIONS!
- CONTENTS
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 2. INTRODUCING T10S SUBWOOFER
- 3. OPTIMAL PLACEMENT OF
- YOUR SUBWOOFER
- 4. FEATURES
- 5. AUDIO CONNECTIONS AND LEVEL SETTINGS
- 6. USING CROSSOVER, PHASE, LEVEL &
- REMOTE CONTROLS ON THE REAR PANEL
- 7. TROUBLESHOOTING
- 8. MAINTENANCE
- 9. SHIPPING
- 10. ENVIRONMENTAL INFORMATION
- 11. EU DECLARATION OF CONFORMITY
- 12. WARRANTY TERMS
- 13. TECHNICAL DATA
12 T10S SUBWOOFER MANUAL [ENGLISH]
[3] PHASE SWITCH – Two settings are provided: 0° and 180°
→ 0° Setting the phase switch to the 0° position will make the subwoofer
reproduce the audio in phase with the incoming signal.
→ 180° Setting the phase switch to the 180° position will make the subwoofer
reproduce the audio with a 180° phase shift or inverted phase, relative
to the incoming signal.
The phase setting does not affect the audio through path that feeds the connected
monitor speakers.
[4] LEVEL KNOB – Turn this knob clockwise to increase the subwoofer’s volume, or
counterclockwise to decrease its volume. The “0 dB” setting is matched to the “0”
marks on the ADAM Audio T Series monitors.
[5] BAL. IN CONNECTOR – Use this XLR connector to feed balanced audio with nominal
+4 dBu level as might be found on a professional audio mixer or audio interface.
[6] UNBAL. IN CONNECTOR – Use this RCA connector to feed unbalanced audio
with nominal -10 dBV level as might be found in some audio interfaces, consumer
electronics, AVRs, or computer sound cards.
[7] MAINS POWER CABLE CONNECTOR – The T10S has an ungrounded two-pin mains
power connector for IEC 60320 C17 power cables.