User's Manual

13 T10S SUBWOOFER MANUAL [ENGLISH]
Your T10S subwoofer needs no external amplification, thanks to its built-in amplifier.
The subwoofer can be directly connected to mixing consoles and both balanced and
unbalanced I/O boxes for DAWs. And because all T Series speakers automatically accept
AC mains voltages ranging from 100 V to 240 V, at 50/60 Hz, you don’t have to fuss with
selecting a correct voltage switch setting for safe operation.
On the rear panel of your T10S subwoofer, XLR connectors and RCA connectors respec-
tively accept balanced +4 dBu and unbalanced -10 dBV nominal input levels.
The XLR connector’s wiring follows the industry standard convention: Pin 1 is ground,
Pin 2 is positive [hot] and Pin 3 is negative [cold].
The RCA connectors follow the industry standard convention: Pin is positive [hot],
Sleeve is ground.
To begin using your T10S subwoofer, follow these simple steps:
→ Before making any connections to your T10S subwoofer, make sure the power cord
is unplugged and the Level control knob is set fully counterclockwise to its minimum
setting. Also make sure the equipment you will connect to your subwoofer is turned
off and its output level controls, if any, are turned all the way down.
→ If you’ll be sending balanced +4 dBu analog audio from your mixer, I/O box or
other equipment to your T10S, use the subwoofers’ left and right channel XLR
input connectors
→ If you’ll be sending unbalanced -10 dBV analog audio from your mixer, I/O box,
AVR, or other equipment to your T10S subwoofer, use the subwoofers’ left and right
channel RCA input connectors.
5. AUDIO CONNECTIONS AND
LEVEL SETTINGS