Product Manual

© Adam Equipment 2016 12
** To calibrate in pounds (lb) make sure that the scale is lb mode before
commencing, to calibrate in kilograms (kg) make sure the scale is in kg mode before
commencing.
When using slings, chains or other material to support the calibration mass, these
items should be hung from the scale before setting the zero point so that when the
calibration mass is added, only the weight of the calibration mass is measured by
the scale.
If an error is detected when calibrating an error message will be shown.
Err 3 is when wrong data is entered for the mass, i.e. too small or wrong division.
Err-5 means the calibration has failed.
5.0 PARAMETER
5.1 ENTER SETTING MODE
Turn off the power of the scale and then turn the power on again.
Press the [Change/lb/kg] key during self-checking, display shows “Bee0“, indicating
the scale has entered the setting mode, press the [Hold] or [Change/lb/kg] key to
shift the parameter items. Use [Zero] key confirm and escape from setting the
current item.