Installation Instructions
Page 5 - Revision 03
HORIZONTAL LINE
VERTICAL LINE
HORIZONTAL LINE
VERTICAL LINE
Remove the Slide and hold
the Plastic Bracket on the
cabinet back wall making
sure to line up the top of
Plastic Bracket with the
horizontal line made in Step
B1 and the center of Plastic
Bracket holes placed on the
vertical line.
Mark the location of the two
holes in the Plastic Bracket.
Drill 1/16” pilot holes in the cabinet
back wall and install the Plastic
Bracket using (2) Slide Screws.
Insert Slide in the Plastic Bracket and
reinstall the Slide Screw in the front
mounting bracket hole in the Slide.
REPEAT THESE STEPS ON THE RIGHT
SIDE OF CABINET USING SAME
MEASUREMENTS AS THE LEFT SIDE.
Install the Basket onto the Slides using four
Rack Screws.
NOTE:
If the Slides are not installed parallel, they may bind or be difcult to move during operation.
Remove the Rack and check the operation of each Slide.
With the Rack removed, if the Slides do not bind when opening and closing, the installation
should be adjusted to make the Slides parallel, both horiztonally and vertically.
Step B5
Step B6
Step B7
Step B8
Side Mount (w/o Adapter Block) - STOP