Installation Instructions

Page 6 - Revision 03
Prepare the Adapter Kit for use by
inserting two Hex Nuts into the
hex slots on one Adapter Block
and threading a Phillips Screw
into each Hex Nut. Repeat for the
second Adapter Block.
DO NOT fully tighten the Phillips
Screws.
Hold the left Slide against the inside of the
cabinet at the desired height. Locate
the pre-drilled cabinet holes that are
closest, vertically, to the center of the
bracket on the Slide.
Remove the Slide and make a pencil
mark to record the hole location. Mark
the same hole location on the right side
of the cabinet.
NOTE: Take into consideration the sizes of
items that will be placed in the Basket
and additional Baskets or other products
that may be installed.
NOTE: If you need to drill holes in your
cabinet to mount the Adapter Block, use
a 5mm drill bit.
Install the Adapter Block on the
left and right side of the cabinet,
using the two Euro Screws for
each Adapter Block. DO NOT
overtighten the Euro Screws to
avoid stripping out the pre-drilled
holes.
NOTE: Make sure the Phillips Screws
are on the side of the Adapter
Block at the front of the cabinet.
Remove the Phillps Screws from both
Adapter Blocks.
STEP C1
Step C2
Step C3
Step C4
Side Mount with Adapter Block - START HERE