Installation Instructions

Page 7 - Revision 03
LEVEL
LEVEL
Temporarily install the left Slide onto
the left Adapter Block using two
Phillips Screws. Make sure to hold
the Slide Level.
Use a tape measure and record
the height from the bottom of the
cabinet to the top of the bracket
on the front of the Slide.
While holding the left Slide level and
parallel to the inside wall, measure
from the inside wall to the center
of the front hole in the top of the
Slide.
Remove the left Slide from the Adapter Block by removing the Phillips Screws.
Mark a horizontal line on the back wall of the cabinet at the same height as measured
in Step C5, close to where the left and right Plastic Brackets will be located.
Mark a vertical line on the back wall of the cabinet the same distance measured in
Step C5 from the cabinet side wall, for both the left and right side of the cabinet.
NOTE: The top of the front mounting bracket on the Slide and the top of the Plastic
Bracket should be the same height from the cabinet bottom.
The front bracket on the Slide should not extend beyond the front of the cabinet face
frame or it will interfere with the closing of the cabinet door.
Step C5
Step C6