Installation Instructions

Page 8 - Revision 03
HORIZONTAL LINE
VERTICAL LINE
HORIZONTAL LINE
VERTICAL LINE
Hold the left Plastic Bracket
on the cabinet back wall
making sure to line up the
top of Plastic Bracket with
the horizontal line made in
Step C6 and the center of
Plastic Bracket holes placed
on the vertical line.
Mark the location of the two
holes in the Plastic Bracket.
Repeat this step for the right
Plastic Bracket.
Drill 1/16” pilot holes in the cabinet
back wall and install both Plastic
Brackets using (4) Slide Screws.
Insert the Slides in the Plastic
Brackets and attach each Slide to
its Adapter Block using the Phillips
Screws.
Install the Basket onto the Slides using four Rack Screws.
NOTE:
If the Slides are not installed parallel, they may bind or be difcult to move during operation.
Remove the Rack and check the operation of each Slide.
With the Rack removed, if the Slides do not bind when opening and closing, the installation
should be adjusted to make the Slides parallel, both horiztonally and vertically.
Step C7
Step C8
Step C8
Step C8
Side Mount with Adapter Block - STOP