Installation Instructions
Page 3 - Revision 03
Using a pencil, mark the location of two mounting
holes in each of the brackets on the front of the
Slides. Also mark the two mounting holes in each
Plastic Bracket on the cabinet back wall.
Remove the assembly from the
cabinet. Drill 1/16” pilot holes
in each location marked in the
cabinet.
Remove the Plastic Brackets from
the assembly and mount to the
cabinet rear wall using four Slide
Screws.
Replace the assembly in the cabinet by inserting
the ends of the Slides into the Plastic Brackets.
Attach the Slides to the cabinet bottom using
four of the Slide Screws.
NOTE: It may be necessary to remove the Bottom
Shelf from the Slides in order to properly drive in
the Slide Screws.
STEP 5
STEP 6
STEP 7
STEP 8
NOTE:
If the Slides are not installed parallel, they may bind or be difcult to move during operation.
Remove the Rack and check the operation of each Slide.
With the Rack removed, if the Slides do not bind when opening and closing, the installation
should be adjusted to make the Slides parallel, both horiztonally and vertically.