Installation Instructions

ManualsBrandsadapt ManualsCabinet Organization & Accessoriesadapt.™ 15" Soft-Close Chrome Cookware Organizer - 2-Piece

P. 1

4814116 K-6951A 15” Cookware organizer instruction

Mounting chart

Note: See instruction for side mount of bottom mount installation.

Description

Side mount Bottom mount

15” Rack 15” opening required Install on

bottom of

cabinet 15” or

wider

Parts list

#2 #3

DESCRIPTION QTY

#1. Bottom cookware rack 1

#2. Sliders 2 sets

#3. Plastic mounting brackets

#4. Slider mounting screws 16

#5. Rack mounting screws 8

#6. Upper lid rack 1

REQUIRED TOOLS

(not provided)

⊙ Drill

⊙ 1/16" Drillbit

⊙ Screwdriver

⊙ Tape measure

⊙ Level

Summary of content (6 pages)

PAGE 1
Mounting chart Note: See instruction for side mount of bottom mount installation. Description Side mount 15” Rack Bottom mount 15” opening required Install on bottom of cabinet 15” or wider Parts list #1 #2 #3 #4 #5 #6 DESCRIPTION #1. Bottom cookware rack #2. Sliders #3. Plastic mounting brackets #4. Slider mounting screws #5. Rack mounting screws #6. Upper lid rack QTY 1 2 sets 4 16 8 1 P.
PAGE 2
Bottom cookware rack mounting instruction Step 1 Screw cookware rack (#1) to the sliders (#2) using 4 (#5) screws. Make sure the front of the cookware rack is located on the end of the slider with the large bracket. Step 2 Place plastic mounting brackets (#3) on sliders (#2) and place assembly in cabinet at desired location. Step 3 Using a pencil, mark the mounting holes (2) in the front brackets and (2) in the plastic mounting brackets for each slider. P.
PAGE 3
Bottom mounting instruction – continued. Step 4 Remove cookware rack assembly from cabinet and drill 1/16” pilot holes in the marked locations. . Step 5 Screw plastic mounting brackets to back wall using 4 screws (#4). Step 6 Reinstall the cookware rack assembly in plastic mounting brackets and install 4 screws (#4) in the predrilled pilot holes of front mounting bracket.
PAGE 4
Upper lid rack side mounting instruction Step 1 Hold the left hand slider (#2) against the insider of the cabinet face frame at desired height (Typically between 14”- 15”). Make a pencil mark at the top of the front bracket. Use a tape measure and record the height from the bottom of the cabinet to this mark. Note: Take in to consideration the sizes of items that will be stored.
PAGE 5
Upper lid rack side mounting instruction – continued. Step 4 While holding the slider level and parallel to the inside wall, measure from inside wall to the center of front hole in the top of the slider. Record this dimension and mark it on the back wall on the line from step #2.
PAGE 6
Upper lid rack side mounting instruction – continued. Step 6 Drill 1/16” pilot holes in the back wall and install plastic mounting bracket using (2) #4 screws. Step 7 Insert slider in the back plastic mounting bracket and reinstall screw (#4) in the front mounting bracket hole. Repeat steps on the right side of cabinet using same measurements as left side. Step 8 Install upper lid rack (#6) to sliders (#2) using basket mounting screws (#5) P.