User Manual

7
Troubleshooting
4
Double-click the
SCSI Controller
icon. The software driver for
the Adaptec SCSI Card 29160N is listed as “29160, 29160N,
29160B, CPQ29160, Ultra160 PCI SCSI Controller.”
■
If the driver is listed, the Adaptec SCSI Card 29160N driver
is loading properly.
■
If the driver is listed but has an exclamation mark inside a
yellow circle the software driver may conflict with other
hardware using the same resources. Double-click the icon
to see the device status and possible solutions.
■
If the driver is listed but has an “X” inside a red circle, the
Adaptec SCSI Card 29160N software driver is disabled and
isn’t loading.
■
If the SCSI Controller icon or the Adaptec SCSI Card
29160N software driver is not listed, reinstall the driver.
Note:
In order to accommodate any special OEM system
requirements, Adaptec may provide special driver software
that is different from Adaptec standard driver software if
the board is pre-installed. Be sure to use the driver software
provided by the computer manufacturer.
An “X” inside a red circle appears with the Adaptec SCSI Card 29160N
software driver in Device Manager. What does this mean?
It means that the Adaptec SCSI Card 29160N software driver is dis-
abled and isn’t loading.
To enable the driver
1
Double-click the Adaptec SCSI Card 29160N software driver in
Device Manager.
2
Under the
General
tab, click the Original Configuration (cur-
rent) box.