User Manual

17
Configuring the Adaptec SCSI Card 29160N with SCSISelect
Configuring the
Adaptec SCSI Card 29160N
with SCSI
Select
SCSI
Select,
included with the Adaptec SCSI Card 29160N, enables
you to change SCSI settings without opening the computer or han-
dling the card. SCSI
Select
also enables you to low-level format or
verify the disk media of your SCSI hard disk drives. The following
table lists the available and default settings for each SCSI
Select
option.
Note:
The default settings are appropriate for most systems.
Run SCSI
Select
if you need to change or view current set-
tings, or if you would like to run the SCSI disk utilities. See
the descriptions of each option starting on page 19.
SCSI
Select
Options Available Settings Default Setting
Basic Host Adapter Options:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination:
Ultra160-LVD Connector Automatic, Enabled,
Disabled
Automatic
Fast/Ultra-SE Connector Automatic, Enabled,
Disabled
Automatic
Boot Device Settings:
Boot Target ID 0-15 0
Boot LUN Number
1
0-7 0
SCSI Device Configuration Options:
Maximum Sync Transfer Rate (MBytes/sec) 160.0, 80.0, 53.4,
40.0, 32.0, 26.8,
20.0, 16.0, 13.4,
10.0, ASYN
160.0
Enable Disconnection Yes, No Yes (Enabled)
Initiate Wide Negotiation Yes, No Yes (Enabled)