User`s guide

4-11
RAIDUTIL Command Line Utility
-I Display inquiry information
This switch displays controller specific information, including
firmware revision, BIOS version, and serial number. Specify drives
by the device address.
-L List devices
Specify drives by the device address. The parameters for this
switch are listed below:
Note: If a controller is not specified then each controller is
listed, along with all devices on each controller.
Controller Displays a list of all Adaptec controllers in the
system.
Physical Displays all attached devices to the specified
controller.
Logical Displays a list of all logical drives on the controller,
by logical drive number.
Spare Displays a list of all stand-alone hot spare drives.
RAID Displays a list of all configured RAIDs.
Array Speed Displays a list of the bus speed of all connected
drives.
Redirect Displays any redirected devices.
Version Displays the controller firmware, SMOR, NVRAM,
and BIOS version numbers.
Cache Displays the device caching mode.
Inquiry Displays the device capabilities as reported to the
controller.
Battery Displays information about the battery backup
module.
All Prints out all of the above.
Combined RAID SW-UG.book Page 11 Monday, September 9, 2002 1:25 PM