User`s guide

Chapter 8: Configuring the Adaptec SCSI Card with SCSISelect ● 35
The following table lists the available and default settings for each SCSISelect option.
The default settings are appropriate for most systems and should not be changed. Run
SCSISelect if you need to change or view current settings, or if you need to use the SCSI disk
utilities.
SCSISelect Options Available Settings Default Setting
SCSI Bus Interface Definitions:
SCSI card ID 0-15 7
SCSI card Parity Enabled
Disabled
Enabled
SCSI card Termination: Automatic, Enabled, Disabled Automatic
Boot Device Configuration Options
—BBS Systems Only:
Select Master SCSI card A A
Boot Device Configuration
—Non-BBS systems Only:
Select Master SCSI card A A
Boot SCSI ID 0-15 0
Boot LUN Number
1
1
Setting is valid only if Multiple LUN Support is enabled.
0-7 0
SCSI Device Configuration Options:
Sync Transfer Rate (MB/sec) 320, 160, 80.0, 66.6, 40.0, 33.3,
20.0, 10.0, ASYN
320
Packetized Yes, No Yes (Enabled)
QAS Yes, No Yes (Enabled)
Initiate Wide Negotiation Yes, No Yes (Enabled)
Enable Disconnection Yes, No Yes (Enabled)
Send Start Unit Command Yes, No Yes (Enabled)
BIOS Multiple LUN Support
1
Yes, No No (Disabled)
Include in BIOS Scan
1
Yes, No Yes (Enabled)
Advanced Configuration:
Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled
Display <Ctrl> <A> Messages during BIOS
Initialization
Enabled, Disabled Enabled
Extended INT 13 Translation for
DOS Drives > 1 GB
Enabled, Disabled Enabled
Post Display Mode Verbose, Silent, Diagnostic Verbose
SCSI card INT 13 Support Enabled
Disabled: Scan
Bus Disabled: Not
Scan
Enabled
Domain Validation Enabled, Disabled Enabled
Support Removable Disks Under
INT 13 as Fixed Disks
2
2
Settings are valid only if the controller BIOS (SCSI card INT 13 Support) is enabled.
Disabled,
Boot Only,
All Disks
Disabled
BIOS Support for Bootable CD-ROM
2
Enabled, Disabled Enabled