User`s guide

Appendix E: Using the Adaptec Flash Utility ● 123
Updating the Flash Using the AFU Command
Line
1 Create the firmware floppy disks (see page 117).
2 Power off your computer, insert the first AFU floppy disk, then
power on your computer.
If your computer isn’t set up to boot from the bootable floppy disk,
enter the system setup utility to change the setting.
3 At the DOS command, if you have multiple controllers and you don’t
know the number of the controller you want to update, type
AFU LIST ,
then press
Enter . Otherwise, skip to the next step.
4 At the DOS command, type AFU followed by a command (see page
119) and any switches you want.
5 Update the flash using the instructions suitable for your
requirements:
● To update a single RAID controller:
AFU UPDATE /C <cont_number>
Where <cont_number> is the number of the RAID controller
whose firmware you are updating. For example, to upgrade
Controller 0, type
AFU UPDATE /C 0
● To update multiple RAID controllers:
AFU UPDATE /C <cont_number_a>,<cont_number_b>
Where <controller_number_a> and <controller_number_b> are the
numbers of the Adaptec RAID controllers whose firmware you
are updating. For example, to upgrade controllers 0, 2, and 3,
type
AFU UPDATE /C 0, 2, 3
● To update all RAID controllers simultaneously :
AFU UPDATE /C all
Note: The UFI file identifies the RAID controllers, so you don’t
have to worry about flashing the wrong controller.