Specifications

9
Installing the Hardware
Figure 4. Installing the Cable
Removing the GBIC
To remove the GBIC, follow these steps:
1 Remove the Fibre Channel cable.
a If you are using the IBM optical GBIC, flip the bar of the
GBIC to the OPEN position and pull to remove. See Figure 5
on page 10.
b If you are using the HSSDC copper cable, squeeze the tab on
the cable to remove. See Figure 6 on page 10.
c If you are using the HSSDC or the DB9 copper GBIC,
squeeze the tabs on both sides of the GBIC. See Figure 6 on
page 10 or Figure 7 on page 10.
d If you are using the DB9 copper cable, loosen the screws on
either side of the cable connector and pull out to remove.
See Figure 7 on page 10.
2 Pull the module out of the receptacle.
Copper (DB9)