Specifications

11
Installing the Hardware
Verifying the Adapter
You can verify the adapter and cable installation by powering up the
system and looking at the two LEDs on the bulkhead of the adapter.
See Figure 8 on page 11. Under normal operation, the LEDs operate
as follows:
Upon Power-up
■ PWR/ACT LED is on
■ LNK LED is off
During Card Initialization by the Host OS
■ PWR/ACT LED will flash as Fibre Channel devices are
identified
■ LNK LED is off
Once the Card has been Initialized by the Host OS
■ PWR/ACT LED will flash at approximately one second
intervals
■ LNK LED is on if the adapter is operating properly
Figure 8. Front View of Bracket