Installation guide

6-6
AAA-UDMA Installation and Hardware Guide
21
When the server starts, type
down
in the NetWare console.
Change the
autoexec.bat
file and the
config.bat
file to recog-
nize the CD drive. NetWare would have changed these files
during installation. The old files are saved as
autoexec.000
and
config.000
. Reboot the system.
22
Change to the
c:\nwserver
directory and enter:
server
23
At this point, install Adaptec CI/O Management Software
from the server console. Refer to the
Adaptec CI/O Management
Software User’s Guide
for instructions on installing and using
the software.
Installing the Driver When NetWare is Already Installed
To update or install the
cdaudmah.ham
driver if NetWare is already
installed, follow the instructions below for the version of NetWare
you have installed.
NetWare 4.11
1
Copy the
cdaudmah.ham
file from the Adaptec
Array1000UDMA Family Manager Set driver disk into the
server’s startup directory (e.g.,
c:\nwserver
) on your hard disk.
Note:
For NetWare 4.1, the
cdaudmah.ham
file is in
a:\v4_1x
.
2
If necessary, modify the
load
command line in the
startup.ncf
so that the proper path to the driver is specified. The correct
syntax to load the
cdaudmah.ham
driver is
load [pathname]cdaudma
NetWare 4.2 and 5.0
1
Copy the
cdaudmah.ham
file from the Adaptec
Array1000UDMA Family Manager Set driver disk into the
server’s startup directory (e.g.,
c:\nwserver
) on your hard disk.