Installation guide

9
SCSI Card 2906
5
Connect the other end of the cable to the last internal SCSI
device as shown below (this SCSI device must be terminated;
see Step 2 above).
Make sure Pin 1 on the cable aligns with Pin 1 of the internal
SCSI device’s connector. Pin 1 usually is designated by a small
triangle or “1”.
6
Connect the remaining connectors on the cable to any remain-
ing internal SCSI devices as shown below (do not terminate
these SCSI devices; see Step 2 above.)
Terminated Internal
SCSI Device
Internal SCSI Cable
Terminated Internal
SCSI Device
Unterminated Internal
SCSI Device