Installation guide

15
SCSI Card 2906
Note:
If the driver is not listed or is not loading properly, see
the Troubleshooting section of the SCSI Card 2906 User’s Refer-
ence.
Computers with Windows

NT 4.0
1
Start Windows NT 4.0
2
Click the Start button, point to Settings, and then double-click
Control Panel.
3
Double-click SCSI Adapters.
4
In the SCSI Adapters window, click the Drivers tab.
5
In the Drivers tab, click Add.
6
In the Install Driver window, click Have Disk.
7
Insert the Adaptec EZ-SCSI diskette for Windows 95/98 and
Windows NT into the floppy disk drive.
8
In the Install from Disk window, type
a:\winnt\4_0
and then
click OK.
9
Click Adaptec AIC-7850 PCI SCSI Controller Driver from the
list.
Note:
If an Adaptec AIC78xx driver is already installed, you
will be prompted for the current or new driver installation.
Click New.
10
Restart your computer.
Computer with Windows 3.1/DOS
1
Turn on all external SCSI devices and then the computer.
2
Start Windows 3.1 on your computer and wait for the start-up
process to finish.
3
Insert the Adaptec EZ-SCSI diskette for DOS and Windows 3.1
into the floppy disk drive.