Installation guide

4
SCSI Card 2906
Determine which SCSI devices will be connected to the computer. If
you want to connect more than two internal SCSI devices or one or
more external SCSI devices, you will need additional cables not
included in this package. These cables are described in the SCSI Card
2906 User’s Reference.
Installing the SCSI Card 2906
WARNING:
Before you start, turn
OFF
power to the computer
and disconnect the power cord. Then ground yourself by
touching an unpainted surface of the computer case.
1
Remove the cover from your computer, following the manu-
facturer’s instructions.
2
Find an unused PCI expansion slot (typically white or ivory) in
your computer. Unscrew the expansion slot cover screw and
remove the cover to provide an opening as shown in the fol-
lowing diagram.
Note:
If your computer is a tower model, it is easier to install
the SCSI card when the tower is laid on its side. Computers
may have vertical or horizontal expansion slots, as shown in
the following diagram. Refer to your computer manual to
locate the PCI slots.