Installation guide

3-74
container Commands
/raid5{=boolean}
Specifies whether to reconfigure the existing array into a
RAID 5 array. If you specify TRUE, the command reconfigures
the existing array into a RAID 5 array. If you specify FALSE,
the command does not reconfigure the existing array into a
RAID 5 array.
This switch defaults to FALSE.
/raid10{=boolean}
Specifies whether to reconfigure the existing array into a
RAID 10 array. If you specify TRUE, the command
reconfigures the existing array into a RAID 10 array. If you
specify FALSE, the command does not reconfigure the
existing array into a RAID 10 array.
This switch defaults to FALSE.
/stripe{=boolean}
Specifies whether to reconfigure the existing array into a stripe
set. If you specify
TRUE , the command reconfigures the existing
array into a stripe set. If you specify
FALSE , the command does
not reconfigure the existing array into a stripe set.
This switch defaults to FALSE.
/volume{=boolean}
Specifies whether to reconfigure the existing array into a
volume set. If you specify TRUE, the command reconfigures
the existing array into a volume set. If you specify FALSE, the
command does not reconfigure the existing array into a
volume set.
This switch defaults to FALSE.
/wait{=boolean}
Specifies whether the command performs the array
reconfiguration operation synchronously or asynchronously.
If you set this switch to TRUE, the command performs the
array reconfiguration operation synchronously, which means
the command prompt does not return until the array
reconfiguration operation completes. If you set this switch to
FALSE, the command performs the array reconfiguration
operation asynchronously, which means the command
prompt returns immediately.