Installation guide

3-83
container Commands
The following example removes the file system from array 0:
AAC0>container remove file_system 0
Executing: container remove file_system 0
Use the container list command after removing a file system
from an array with the container remove file_system
command to display information about the container, as in the
following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB None 0:02:0 64.0KB: 10.0MB
As a result of removing a file system from an array, the Usage
column displays None (instead of NTFS)
to indicate that the
specified array no longer has a file system.
Related Commands
container commands:
■ container format (page 3-50)
■ container list (page 3-50)