Installation guide

3-100
container Commands
The following example creates a mirror set asynchronously and
sets an I/O delay of 20 milliseconds for array 0. You need to
perform the create mirror task asynchronously. Otherwise, you
cannot change the I/O delay:
container create mirror /io_delay=20 0 (0,2,0)
Executing container create mirror /io_delay=20 0 (CHANNEL=0,ID=2,LUN=0)
The following example shows how to change the I/O delay to 40
milliseconds on the currently running create mirror task:
AAC0>container set io_delay 0 40
Executing: container set io_delay 0 40
Use the container list command after using the container
set io_delay
command to display information about the array,
as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB
As the example shows, there is no difference between the array list
display prior to and after the set I/O delay operation.
Related Commands
container commands:
■ container create mirror (page 3-5)
■ container create mmirror (page 3-8)
■ container list (page 3-50)
■ container scrub (page 3-88)