Installation guide

3-101
container Commands
container set label
To assign a new label to the specified array or to assign a label to an
array that has no label, use the container set label
command.
The following commands have a
/label switch that allows you to
assign a label to the array when you create it:
■ container create mstripe (a multilevel stripe set)
■ container create mvolume (a multilevel volume set)
■ container create raid5 (a RAID 5 array)
■ container create stripe (a stripe set)
■ container create volume (a volume set)
The label you specify with the container set label command
and the /label switch associated with the previously listed
container create commands is not the label that displays in
Windows Explorer. The label displayed by Windows Explorer
comes from the label specified with the container format
command.
Syntax
container set label {container} {string}
Parameters
{container}
Specifies the ID number (0 to 63) of the array to which you
want to assign a label.
{string}
Specifies the label you want to assign to the array. The label is
a string of up to sixteen characters.