Installation guide

3-102
container Commands
Examples
Before assigning a label to a specific array, use the container
list
command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with no label assigned to it (as evidenced by no
label in the Num Label column):
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB
The following example assigns the label Tigris to array 0:
AAC0>container set label 0 Tigris
Executing: container set label 0 "Tigris"
Use the container list command after using the container
set label
command to display the new label, as in the following
example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB
Tigris
As the example shows, the new label Tigris now appears in the
Num Label column.
Related Commands
container commands:
■ container create mstripe (page 3-12)
■ container create mvolume (page 3-17)
■ container create raid5 (page 3-21)
■ container create stripe (page 3-27)
■ container create volume (page 3-32)
■ container format (page 3-50)