Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
4-6
controller Commands
controller firmware compare
To compare the contents of each of the flash components on a
controller to the corresponding image in a pair of user flash image
(UFI) files and indicate whether they match, use the controller
firmware compare command.
Syntax
controller firmware compare
[/C[{controller_ID}][{controller_ID}...]
[/D{UFI_file_path}]
Switches
/C{controller_ID}
Specifies the controller ID representing the set of controllers
on which to perform the firmware comparison.
If you do not specify this switch, this command compares the
flash components on controller 0.
/D{UFI_file_path}
Specifies the path where the pair of UFI files are located.
If you do not specify this switch, this command compares the
flash components against the pair of UFI files in the current
default drive and directory.
Examples
The following example compares the contents of a controller’s
flash components to the corresponding image in a pair of UFI files.
AAC0> controller firmware compare D:\
Executing: controller firmware compare “D:\”
The controller’s firmware matches the firmware in the specified flash
image files.
Related Commands
controller commands:
■ controller firmware save (page 4-7)
■ controller firmware update (page 4-9)