Installation guide

5-23
disk Commands
/full{=boolean}
Specifies whether to display detailed S.M.A.R.T.
configuration information for one or all SCSI disks. If you
specify TRUE, the command displays detailed S.M.A.R.T.
configuration information. If you specify FALSE, the
command does not display detailed S.M.A.R.T. configuration
information.
This switch defaults to FALSE.
/view_changeable{=boolean}
Specifies whether to display the configuration information
that can be set on a S.M.A.R.T. disk. If you specify TRUE for
this switch, the command displays the letter “X” in the
column for the configuration information that can be set. For
example, an “X” appears in the Enable Exception Control
column for those S.M.A.R.T. disks on which this value can be
set.
This switch defaults to FALSE.
Examples
The following example shows how to display nondetailed
S.M.A.R.T. configuration information for all disks on the system:
AAC0>disk show smart
Executing: disk show smart
Smart Method of Enable
Capable Informational Exception Performance Error
C:ID:L Device Exceptions(MRIE) Control Enabled Count
------ ------- ---------------- --------- ----------- ----
3:00:0 N
3:01:0 N
3:02:0 N
3:03:0 N
The detailed disk show smart display contains the previous
columns of information plus the following columns:
■ Log Errors
■ Interval Timer (secs.)
■ Report Count
The following sections provide more information on the columns
that the disk show smart command displays.