Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
5-25
disk Commands
The Log Errors Column
The Log Errors column displays the value Y if you enabled log
errors or N if you did not enable log errors. You enable log errors
by using the disk set smart command’s /logerr switch.
If you specified the /view_changeable switch, the command
displays an X in this column for those disks on which you can
enable log errors.
The Interval Timer (secs.) Column
The Interval Timer (secs.) column displays the number of seconds
specified for the exception reporting interval. If you specified the /
view_changeable switch, the command displays an X in this
column for those disks on which you can set the number of seconds
for the exception reporting interval.
The Report Count Column
The Report Count column displays the number of times you
specified for exceptions to be reported. You specify this number by
using the disk set smart command’s /report_count switch.
The Error Count Column
The Error Count column displays the number of errors that
S.M.A.R.T. encountered on the disk.
If you specified the /view_changeable switch, the command
displays an X in this column for those disks on which you can
enable the recording of errors that S.M.A.R.T. encounters on the
disk.
Related Commands
disk commands:
■ disk set smart (page 5-13)