Installation guide

5-26
disk Commands
disk show space
To display space usage information on a SCSI disk, use the disk
show space command.
Syntax
disk show space [/all{=boolean}] [{scsi_device}]
Parameters
{scsi_device}
Specifies the ID for the SCSI device for which you want to
display space usage information. A SCSI ID consists of a SCSI
channel number (for example, 0, 1, 2, 3, etc.), a SCSI device ID
(0 through 15 inclusive), and a SCSI device logical unit
number (0 through 7 inclusive).
For further details, see scsi_device on page 1-10.
Switches
/all{=boolean}
Specifies whether to show space usage information for all
SCSI disks on the currently opened controller. If you set this
switch to TRUE, the command shows space usage information
for all SCSI disks on the currently opened controller.
This switch defaults to FALSE if you specify the
scsi_device parameter; otherwise, the switch defaults to
TRUE.
Examples
The following example shows space usage information for all of
the SCSI disks on the currently opened controller:
AAC0>disk show space
Executing: disk show space
Scsi C:ID:L Usage Size
----------- --------- -------------
0:02:0 Array 64.0KB: 20.0MB
0:02:0 Free 20.0MB: 29.0MB
0:03:0 Free 64.0KB: 49.0MB
0:04:0 Free 64.0KB: 49.0MB
0:05:0 Free 64.0KB: 49.0MB