Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
6-4
diagnostic Commands
diagnostic dump text
To display diagnostic information on the console display for use by
technical support during bug reporting, use the diagnostic
dump text command.
Caution: Use this command only under the direction of
technical support.
Notes
Before using this command in DOS, verify that the window is set to
scroll data. For details, refer to your DOS documentation.
Before using this command on other operating systems, you might
want to make sure your windowing system is set up to scroll data.
See your operating system documentation.
You might also want to use the
logfile start
command to make
sure the diagnostic-related information gets sent to the logfile.
Syntax
diagnostic dump text
Examples
The following example displays diagnostic information on the
console display:
AAC0>diagnostic dump text
Executing: diagnostic dump text
Partitions:6
The command displays a variety of information in table format. It
also displays:
*** HISTORY BUFFER FROM LAST RUN ***
[00]:
*** HISTORY BUFFER FROM CURRENT CONTROLLER RUN ***
[00]:
==============
Dump Complete.
!