Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
1-14
Introduction
The Ctr and State Items
The Ctr item displays the ID number of the array associated with
the task. In the example, the array’s ID is 0 (zero).
The State item displays the state of the task along with a running
percentage value that indicates the progress of the currently
running task. The item shows the percentage in tenths of a percent
increments. The currently running task is complete when the State
item displays 100%.
MMR Merge a broken mirror task.
The array merge command causes the MMR value to
display.
MSC array scrub task. The array scrub command causes the
MSC value to display.
NTF array format task with an NTFS file system specified. The
array format command with the /file_system switch
set to NTFS causes the NTF value to display.
R5R RAID-5 rebuild task.
R5S RAID 5 array create task with the scrub method specified. The
array create raid5 command with the /scrub switch
specified causes the R5S value to display.
RCF array reconfigure task. The array reconfigure command
causes the RCF value to display.
SCV Verify all blocks on a SCSI disk device task. The disk
verify command causes the SCV value to display.
SCZ Clear an entire SCSI disk task. The disk zero command
causes the SCZ value to display.
SVR Verify all blocks and repair bad blocks on a SCSI disk device
task. The disk verify command with the /repair switch
causes the SVR value to display.
Table 1-7 Function Values (Continued)
Value Meaning