Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
8-4
task Commands
NTFSfmt An array format NTFS file system task is running on the
specified array. The format NTFS file system task runs as a
result of using the
array format command with the /
file_system
switch set to NTFS.
Rebuild A rebuild task is running on the specified array. Typically,
the rebuild task runs when the controller is in a rebuild of a
redundant array (RAID 5 array, mirror set, or multilevel
array of mirror sets).
Reconfg An array reconfigure task is running on the specified array.
When the array reconfigure task completes, the specified
array becomes a different array (for example, from a
volume set to a stripe set). The array reconfigure task runs
as a result of using the
array reconfigure
command.
Scrub A scrub task is running on the specified redundant array.
When the scrub task completes, the specified redundant
array has reconstructed data on one partition based on data
found on the other partition (for mirror sets and multilevel
arrays of mirror sets). Or, the specified redundant array
recalculates and replaces, if necessary, the parity
information (for RAID 5 arrays). The scrub task runs as a
result of the
array scrub command. The scrub task
also runs as a result of the
array create raid5
command with the
/scrub switch specified.
This is the task type displayed in the example.
Unknown An unknown task is running.
Table 8-1 Task Types (Continued)
Task Type Meaning