Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
8-5
task Commands
The Done% Column
The Done% column displays a running percentage value that
indicates the progress of the currently running task. The display
shows the percentage in tenths of a percent increments. The
currently running task is complete when the Done % column
displays 100%.
The Array Column
The Array column displays the ID number of the array associated
with the task (if any). In the example, the array’s ID is 0 (zero).
Verify A verify with no repair of bad blocks task is running on the
specified SCSI disk. When the verify with no repair of bad
blocks task completes, the specified SCSI disk’s blocks were
verified without repairing any detected defects. The verify
with no repair of bad blocks task runs as a result of using
the
disk verify command without specifying the
/repair switch.
Or, a verify with repair of bad blocks task is running on the
specified SCSI disk. When the verify with repair of bad
blocks task completes, the specified SCSI disk’s blocks were
verified and any detected bad blocks were repaired. The
verify with repair of bad blocks task runs as a result of
using the disk verify command with the /repair
switch.
Zero A clear disk task is running on the specified SCSI disk.
When the clear disk task completes, the specified SCSI disk
is cleared (that is, all data is erased and cannot be
recovered). The clear disk task runs as a result of using the
disk zero command.
Table 8-1 Task Types (Continued)
Task Type Meaning