Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
9-7
enclosure Commands
Examples
The following example shows a non-detailed list of components for
enclosure management devices 0 and 1:
AAC0>enclosure list /all=TRUE
Executing: enclosure list /all=TRUE
Enclosure Fan Power Slot Sensor Door ScsiId Speaker Standard
Diagnostic
--------- --- ----- ---- ------ ---- ------ -------- -------- ---------
-
0 1 1 5 1 5 0:06:0 No SAF-TE PASSED
1 1 1 5 1 5 1:06:0 No SAF-TE PASSED
The non-detailed enclosure list display contains the
following columns of information:
■ Enclosure
■ Fan
■ Power
■ Slot
■ Sensor
■ Door
■ ScsiId
■ Speaker
■ Standard
■ Diagnostic
The detailed enclosure list display contains the previous
columns of information plus the following columns:
■ EnclosureId
■ VendorI d
■ ProductId
■ Firmware
The following sections provide brief descriptions of each
enclosure list column.