Installation guide

9-26
enclosure Commands
enclosure show fan
To display the status of a specific fan on a specific SAF-TE
enclosure management device, use the enclosure show fan
command. You can also use this command to display the status of
all fans on the enclosure management device or devices.
Syntax
enclosure show fan [{enclosure}] [{fan}]
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device for which you want to display fan status information.
For this version, the controller supports a maximum of eight
enclosure management devices on each bus.
If you do not specify a unit number, the command displays
the fan status for all enclosure management devices
connected to the controller.
{fan}
Specifies the unit number associated with the fan whose
status you want to display. This integer can range from 0 to 15
inclusive.
If you do not specify a unit number, the command displays
the status for all fans on the enclosure management device or
devices.
Examples
The following example displays the status of all fans on enclosure
management devices 0 and 1:
AAC0>enclosure show fan
Executing: enclosure show fan
Enclosure Fan Status
--------- --- -------------
0 0 OK
1 0 NOT INSTALLED