Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
9-39
enclosure Commands
The Interval Column
The Interval column displays the monitor interval. You can set the
monitor interval with the enclosure set interval command.
In the example, the monitor interval reporting level for both
enclosure management devices is 20 seconds.
The Door and Alarm Columns
The Door column displays the status of the door lock. The
enclosure show status command can display the door lock
status values listed in Table 9-7.
Table 9-7 Door Lock Status Values
The Alarm column displays the status of the audible alarm. The
enclosure show status command can display the audible
alarm status values listed in Table 9-8.
Table 9-8 Audible Alarm Status Values
Related Commands
enclosure commands:
■ enclosure list (page 9-6)
■ enclosure set interval (page 9-17)
■ enclosure show fan (page 9-26)
Status Meaning
LOCKED The door is currently locked.
UNLOCKED The door is currently unlocked or there is no
controllable door lock installed. This is the value
displayed in the example.
UNKNOWN The status of the door lock is not reportable. Or, the
door lock status is unknown.
Status Meaning
ON The alarm is currently on.
OFF The alarm is currently off or there is no alarm
installed. This is the value displayed in the example.