Installation guide
Table Of Contents
- Command Line Interface
- Reference Guide
- Introduction
- General Control Commands
- container Commands
- container add_level
- container create mirror
- container create mmirror
- container create mstripe
- container create mvolume
- container create raid5
- container create stripe
- container create volume
- container delete
- container extend file_system
- container extend mvolume
- container extend volume
- container list
- container lock
- container move
- container promote
- container readonly
- container readwrite
- container reconfigure
- container release_cache
- container remove drive_letter
- container remove failover
- container remove file_system
- container remove global_failover
- container restore RAID5
- container scrub
- container set cache
- container set failover
- container set global_failover
- container set io_delay
- container set label
- container show cache
- container show failover
- container split
- container unlock
- container unmirror
- controller Commands
- controller details
- controller firmware compare
- controller firmware save
- controller firmware update
- controller list
- controller pause_io
- controller rescan
- controller reset_scsi_channel
- controller resume_io
- controller set automatic_failover
- controller set array_verify
- controller show automatic_failover
- controller show channels
- controller show array_verify
- disk Commands
- diagnostic Commands
- diagnostic clear boot_parameters
- diagnostic dump structures
- diagnostic dump text
- diagnostic load_arrays
- diagnostic moderation set count
- diagnostic moderation set timer
- diagnostic moderation show count
- diagnostic moderation show timer
- diagnostic set boot_parameter
- diagnostic show boot_parameter
- diagnostic show history
- logfile Commands
- task Commands
- enclosure Commands
- enclosure activate slot
- enclosure identify slot
- enclosure list
- enclosure prepare slot
- enclosure set alarm
- enclosure set door
- enclosure set fan
- enclosure set interval
- enclosure set power
- enclosure set scsiid
- enclosure set temperature
- enclosure show fan
- enclosure show power
- enclosure show slot
- enclosure show status
- enclosure show temperature
- Automated Scripts
- Reference Guide
9-42
enclosure Commands
As the example shows, the temperature sensor status display
contains the following columns:
■ Enclosure
■ Sensor
■ Temperature
■ Threshold
■ Status
The following sections describe the information that the
enclosure show temperature command can display in these
columns.
The Enclosure Column
The Enclosure column displays the ID associated with the
enclosure management device that you specified on the command
line. If you did not specify an ID, the enclosure show
temperature command displays the IDs for all enclosure
management devices connected to the controller. In the example, 0
is specified.
The Sensor Column
The Sensor column displays the unit number associated with the
temperature sensor that you specified on the command line. If you
did not specify a unit number, the enclosure show
temperature command displays the unit numbers for all
temperature sensors on the enclosure management device or
devices.
The Temperature Column
The Temperature column displays the internal enclosure
temperature for this temperature sensor, in degrees Fahrenheit. The
temperature can range from -10 degrees to 245 degrees Fahrenheit.
In the example, the temperature is 70 degrees Fahrenheit.