Installation guide

3-4
container Commands
Use the container list command after using the container
add_level
command to display information about the multilevel
volume set, as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 45MB None
63 Stripe 45MB 32KB 0:02:0 64.0KB: 15.0MB
0:03:0 64.0KB: 15.0MB
0:04:0 64.0KB: 15.0MB
The following list describes the change to the display as a result of
creating a multilevel volume set with the container add_level
command:
■ The Num Label column displays two ID numbers. The first
ID (0) is the newly created volume set. The second ID (63) is
the original array (the stripe set).
If you specified a label when creating the multilevel volume
set, it appears in this column. Because no label was specified
when the multilevel volume set was created, no label appears
in the column.
■ The Type column displays two array types: Volume and
Stripe. The Volume array type indicates that the newly
created array is a volume set. This is the array created after
the container add_level
command completes.
The Stripe array type indicates the array whose ID was
specified to the container add_level
command. This is
the original array previously created with the container
create stripe
command.
Related Commands
container commands:
■ container extend mvolume (page 3-43)
■ container list (page 3-50)
■ container promote (page 3-63)