Installation guide

3-50
container Commands
container list
To display information about one or all arrays on the controller, use
the container list
command. The display contains such
information as the container’s ID number and other useful
information. Typically, you use the container list command to
obtain specific information about arrays prior to using other array-
related commands.
Syntax
container list [/all{=boolean}] [/full{=boolean}]
[{container}]
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose
information you want to display. To display information
about all of the arrays on the system, omit the ID number
from the command.
Switches
/all{=boolean}
Specifies whether to list all arrays on the system. If you
specify TRUE, the command displays all arrays on the system.
If you specify FALSE, the command displays only the array
you specify in the command.
This switch defaults to FALSE
if you specify a container.
Otherwise, the switch defaults to TRUE.
/full{=boolean}
Specifies whether to display detailed information. If you
specify TRUE, the command displays detailed information. If
you specify FALSE, the command does not display detailed
information.
This switch defaults to FALSE.