Installation guide

3-52
container Commands
This column also displays the label assigned to the array when the
array was created. If no label was assigned to the array then no
label appears in the column. You can assign labels with the
following commands:
■ container create mstripe
■ container create mvolume
■ container create raid5
■ container create stripe
■ container create volume
■ container set label
If your controller is running on a UNIX operating system, then the
Num Label column also displays a root special file. On UNIX
systems, arrays are associated with root special files not drive
letters.
See your UNIX documentation for information on how to mount
the array or to create a file system.
The Type Column
This column displays the type of array. Table 3-1 describes the type
values that can display in the Type column.
The CLI automatically assigns the array type as a result of creating
arrays with the container create-related commands.
The CLI assigns the array type Reconf
when the array is
reconfigured from one array type to another. The container
reconfigure
command provides switches that allow you to
reconfigure an array into specific array types.
Table 3-1 Container Types
container Type Meaning
Mirror
The container is a mirror set.
Stripe
The container is a stripe set.
Volume
The container is a volume set.
RAID-5
The container is a RAID 5 array.
Reconf
The container was reconfigured.